Bus Bar Embedded PCB
Instead of using etching process to make conductive traces, 500um(14.3oz) or heavier Bus-Bar is made of rolled copper foils by metal fabrication, and it can be embedded in PCB.
In case of conventional High Current PCB, it is necessary to use thick base copper, so material cost is increased, and price of PCB becomes expensive. Total PCB cost can be reduced because Bus Bar is used only necessary area where you would like to use. Also it is possible to mount parts on the bus bar by combining Bus Bar and PCB.
Specification of Bus Bar Embedded PCB
| Bus Bar thickness | 0.5 / 0.6 / 0.8 / 1.0 / 1.2 / 1.6 / 2.0 mm |
|---|---|
| Board thickness | – 3.5mm |
Examples of usage
- Replacement of Bus Bar
- High voltage high current terminal board
- High Voltage Breaker
- Small Mobility